Technician A says that most manufacturers specify replacement of the air filter every 30,000 miles. Technician B says that the air filter should be replaced every year. Which technician is correct? Select one: A. Technician A only B. Technician B only C. Both technicians A and B D. Neither technician A nor B

No two gun barrels will contain identical rifling characteristics, True False

Which of the following is an advantage of PAC? The cost of PAC equipment can be higher than for other cutting processes. A source of electricity is needed. The metal fumes created can be a health hazard. No hazardous or explosive gases are used.

Two-wheel drive should be chosen for firm road surfaces for all of these reasons EXCEPT: A To prevent excessive tire wear. B To prevent damage to the drive train. C ) To increase fucl economy. D To provide increased traction on slippery surfaces.

Review the question, select the best option and then select submit. What happens to the PWC when the throttle is released? The engine shuts off It loses its steering ability It comes to an immediate stop It will enter a sharp turn

Since the heavy contacts are located between the input and the output terminals of the solenoid where possible, it is best to measure the voltage drop from the __ to the __ Select one: a. Positive battery post;solenoid input b. Positive battery post;starter motor input c. Negative battery post;solenoid input d. Negative battery post;starter motor input

How much fuel should be supplied to the engine every 30 seconds? Select one: A. 1 Pint B. 2 Liters C. 4 Pints D. 2 Pints

Technician A says that fuel filters are located in the fuel supply line. Technician B says that fuel filters are located in the fuel return line Which technician is correct? Select one: A. Technician A only B. Technician B only C. Both technicians A and B D. Neither technician A nor B

What is accelerator failure? When your car does not go as fast as you want When the gas pedal gets stuck When you are driving faster than you realize

What should you do if you see a LOTO Lock or Tag device on a belt system? Select the correct answer. Check first, then start the belt to retrieve the stuck bags Leave it alone and do NOT remove the device Crawl onto the belt system to check it out

Which is a classification of overload relays? eutectic shading