For a nonautomatically started motor, the overload protection shall be permitted to be shunted or cut out of the circuit during the starting period of the motor if the device by which the overload protection is shunted or cut out cannot be left in the starting position and if fuses or inverse time circuit breakers rated or set at not over __ percent of the full load current of the motor are located in the circuit so as to be operative during the starting period of the motor. a. 140 b. 115 C. 125 d. 130 e. 400

Thickness gages are available in which of the following? Tappered Ends Standard or Metric Continuous Leaf All the above

Plastic components should be wiped with Motorcraft Metal Surface Prep Wipes prior to applying the RTV on the plastic component. A) TRUE B) FALSE

Select the correct answer and then click the Next button. Which coating classification BEST describes the presence of defects, but no serious corrosion? a. Good b. Fair c. Poor d. Bare

A __ is a theoretically perfect line, point, or plane that is located by a similar feature of the part. Feature control frame Reference point Dimension Datum

Select the correct answer and then click the Next button. What can interrupt cathodic protection and mask corrosion? a. Humidity b. Dissimilar metals c. Disbondment d. Static electricity

Select the correct answer and then click the Next button. What often causes pockets with corrosion grooves? a. Thin spots b. Wrinkled tape c. Holidays d. Air pockets

Select the correct answer and then click the Next button. What is the cause of premature pipeline corrosion? a. Keeping pipe aboveground b. Using cast iron pipe c. Coating failure d. Low product flow

Which type of slack adjuster is offered by most manufacturers because it resists over-adjustment? Select one: a. Stroke-sensing ASAs b. Clearance-sensing ASAs c. Manual slack adjusters d. Six-inch slack adjusters

Self-powered test lights are like regular test lights except that they contain a __ battery. Select one: a. 0.3-volt b. 24-volt C. . $12-volt$ d. 1.5-volt

When carrying out manual handling and you have poor visibility what actions should you take? (Single choice, select one answer.) Assess the area for any potential trip hazards. Try and improve visibility by turning on lights (where available) or using torches. Check the floor area is not slippery. D All the above.