Match each trade term to its correct definition by selecting the correct ans A weld made in a circular hole in one member of a joint fusing that member to another member. square A weld produced between or upon overlapping members with coalescence initiating and occurring at faying surfaces or proceeding from the other surface of one member. square A weld in an edge joint, a flanged butt joint, or a flanged corner joint in which the full thickness of the workpiece ends are fused. square The removal of weld metal and base metal from the weld root side of a welded joint to facilitate complete fusion and complete joint penetration upon subsequent welding from that side. square The symbol designates that the weld should be made to encapsulate the entire joint. square The distance between the centers of adjacent weld segments on one side of a joint. square A continuous weld produced between overlapping members with coalescence initiating and occurring at faying surfaces proceeding from the outer surface of one member.. square

Thickness gages are available in which of the following? Tappered Ends Standard or Metric Continuous Leaf All the above

Plastic components should be wiped with Motorcraft Metal Surface Prep Wipes prior to applying the RTV on the plastic component. A) TRUE B) FALSE

Select the correct answer and then click the Next button. Which coating classification BEST describes the presence of defects, but no serious corrosion? a. Good b. Fair c. Poor d. Bare

A __ is a theoretically perfect line, point, or plane that is located by a similar feature of the part. Feature control frame Reference point Dimension Datum

Select the correct answer and then click the Next button. What can interrupt cathodic protection and mask corrosion? a. Humidity b. Dissimilar metals c. Disbondment d. Static electricity

Select the correct answer and then click the Next button. What often causes pockets with corrosion grooves? a. Thin spots b. Wrinkled tape c. Holidays d. Air pockets

Select the correct answer and then click the Next button. What is the cause of premature pipeline corrosion? a. Keeping pipe aboveground b. Using cast iron pipe c. Coating failure d. Low product flow

Which type of slack adjuster is offered by most manufacturers because it resists over-adjustment? Select one: a. Stroke-sensing ASAs b. Clearance-sensing ASAs c. Manual slack adjusters d. Six-inch slack adjusters

Self-powered test lights are like regular test lights except that they contain a __ battery. Select one: a. 0.3-volt b. 24-volt C. . $12-volt$ d. 1.5-volt

When carrying out manual handling and you have poor visibility what actions should you take? (Single choice, select one answer.) Assess the area for any potential trip hazards. Try and improve visibility by turning on lights (where available) or using torches. Check the floor area is not slippery. D All the above.