Technician A says pump displacement can be calculated to give a value of either gallons per minute or liters per minute. Technician B says most pumps produce roughly I gallon of flow per revolution. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither Anor B

For a None pump handle detection configuration, which timer would end a transaction? No Fuel Timer End Fuel Timer Pump Finish Timer No Hose Timer

What needs to be done at the FMU if the display reads "Turn Pump Handle On?" Change the divide ratio Power reset the FMU Change pump handle detection to End Only Perform a counts test

Short pieces of wood can be turned into a larger, more usable piece by joining them with __ A. butt joint B. end-to-end half-lap joints C. biscuit joints D. rabbet joint

One piece is laid over another and the pieces are fastened together where they touch. lap joint dowel joint biscuit joint Wood joint in which the piece that fits into the dado is notched so that the joint does not show from the front. dado joint blind dado joint edge butt joint

Matching 5 points Match the Technical term with the Informal term of welding processes. SMAW $\square $ GTAW $\square $ GMAW $\square $ FCAW $\square $

Roughening the faying surfaces tends to have which one of the following effects on the strength of an adhesively bonded joint: increase decrease no effect

As far as a truss system goes, the unit of length is important True False

Stairs with a low angle and/or low total rise require which type of stairwell to ensure adequate headroom? longer narrower shorter wider

Many TPMS sensors use __ -plated valve cores in an aluminum valve stem a. Brass b. Aluminum c. Nickel d. Copper

Slippery conditions require a __ that enhances traction and the stability of motion of the vehicle a. Shift solenoid b. Gear ratio c. Fast apply clutch d. Torque converter clutch