Typically, thrust angle is adjusted as close to the vehicle's centerline as possible Select one: OTrue OFalse

Some vehicles do have grease fittings installed on them Select one: 8. From the factory b. On aftermarket parts c. Both A and B d. Neither Anor B

Tech A says that loose ball joints can cause the vehicle to wander Tech B says that loose control arm bushings can cause a vehicle to wander. Who is correct? Select one: a. Tech A b. Tech B c. Both Aand B d. Neither Anor B

A customer has a concern of a bouncy ride.a reduction in steering control, and unusual noises when going over bumps. This would indicate problems in the __ system Select one: a. Fuel b. Ignition c. Exhaust d. Suspension

Ride height is being discussed. Technician A says that ride height can be checked regardless of tire brand, size, or inflation values. Technician B says that ride height can be measured with a fully loaded trunk. Who is correct? Select one: a. Technician A b. Technician B c. Both technicians A and B d. Neither technician A nor B

Which of the following damper spring oscillations by forcing oil through small holes in a piston? Select one: a. Springs b. Shock absorbers c. Control arms d. Axles

What type of tool do manufacturers recommend to use for cutting CPVC piping? pipe cutter miter saw hack saw

PEX pipe has a high resistance to what type of water? soft hot hard

Most valves are named afte their: bonnets ports passageway control device stem routing device actuators

The maximum acceptable (not necessarily normal) pressure drop across an inline air filter is __ psi. Maximum drop defines at which point to change the inline filter element out. a. 10 b.8 c. 2 d. 5

Hot Questions

When installing structured cabling, why is it important to leave a service loop at both ends of the cable run? To make the installation look more professional and organized To increase the tension on the cable, ensuring a tighter fit To ensure that the cable can be easily pulled out for recycling To provide extra cable length for future reconnections or changes

2-Diga 3 requerimientos de codigo que tenemos que cumplir cuando instalamos un branch-circuit para el Laundry y el Water Heater.

TODAS LA MEZCLAS DE REFRIGERANTE TIENEN QUE CARGARSE AL SISTEMA EN FASE LIQUIDA. FALSO. VERDADERO.

Question 16(Multiple Choice Worth 3 points) (Lesson 8.3 LC) If the brake warning light comes on as you are driving, you should slow down and drive the vehicle home have the brake system inspected immediately and repaired as needed shut off the warning light ignore it the first time it happens

What's the best way to unroll a large spool of wire mesh? Cut the mesh at regular intervals. Stand on the open side as you unroll it. Unroll it down a slope. Turn the roll over.

What are the requirements for horizontal cabling in a structured cabling scheme?(Select two.) Must be within 90 m (295 feet)cabling distance of each wall port if using copper cabling. Can only be installed in ceiling spaces, not wall ducts. Must connect user work areas to an intermediate distribution frame (IDF) Must be made of fiber optic cable exclusively. Requires a wireless booster every 50 m to maintain signal strength.

True or False: You should always stand beneath the vehicle while it's being guided in to help the hood technician position the vehicle correctly.

True or False: If the removed oil plug shows any signs of damage, it should be replaced.

True or False: Pit technicians should always clean the Vehicle's grease fittings during service.

True or False: It's possible to check a vehicle's CV boots by hand squeezing them.